Number of decimal placess for accurate mass

Ask or learn about how to use the software or troubleshoot problems
Post Reply
Was a
Posts: 1
Joined: April 15th, 2015, 9:07 am

Number of decimal placess for accurate mass

Post by Was a » May 20th, 2015, 3:15 am

I have imported 2D LC data from MassHunter and can only view spectra labelled with one decimal place. The spectra peak table also shows only m/z values to one decimal place. Is there somewhere to change the number of decimal places for m/z values? I've tried changing the MS Data Binning values but that makes no difference.
Andy

qtao
Posts: 148
Joined: October 7th, 2011, 10:16 am

Re: Number of decimal placess for accurate mass

Post by qtao » May 25th, 2015, 8:56 am

You can change the decimal places displayed by right clicking on the m/z or Channel column header, and then a popup will be shown as below to let you change the decimal places:
Attachments
MSViewer-decimalplaces.jpg
MSViewer-decimalplaces.jpg (15.98 KiB) Viewed 6278 times

Post Reply